Difference between revisions of "2-2d. Event Trigger - Event Handler (practice)"
From Zenitel Wiki
(Created page with "{{stub}} EX1: Set RCO, transfer and send to LOG. EX2: Toggle event. Toggle RCO and Transfer ON/OFF by same DAK key. [[File:2-2d exercise.PNG|left|thumb|500px|System configurat...") |
|||
Line 1: | Line 1: | ||
{{stub}} | {{stub}} | ||
− | |||
− | |||
− | |||
− | |||
− | |||
[[File:2-2d exercise.PNG|left|thumb|500px|System configuration]] | [[File:2-2d exercise.PNG|left|thumb|500px|System configuration]] | ||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
=== Exercise === | === Exercise === | ||
− | ''' | + | '''Call setup:''' |
− | * | + | * The Entrance and the SOS Point should be configured to make a Call Request (623 + 101) to the Control Room. |
+ | |||
+ | '''Set Call Request Forwarding:''' | ||
+ | * When dialing the event trigger number 9533, or when pressing a DAK key programmed to 9533 on the Control Room station, the following features should be activated: | ||
+ | ** Turn on Call Request Forwarding from Control Room station 101 to station 103 (M. Larsen), so that all new call requests will be forwarded to station 103. Use the command "$SCRT" for this. | ||
+ | ** Turn on a lamp (use RCO 3) to signal that call forwarding is active | ||
+ | ** Write to the System LOG that the call forwarding has been activated. Use the LOG "..." statement. | ||
+ | |||
+ | '''Reset Call Request Forwarding:''' | ||
+ | * When dialing the event trigger number 9534, or when pressing a DAK key programmed to 9534 on the Control Room station, the following features should be activated: | ||
+ | ** Turn off Call Request Forwarding for Control Room station 101. Use the command "$SCRT" for this. | ||
+ | ** Turn off the lamp (RCO 3) to signal that call forwarding is not active | ||
+ | ** Write to the System LOG that the call forwarding has been turned off. Use the LOG "..." statement. | ||
Revision as of 16:01, 29 October 2013
Exercise
Call setup:
- The Entrance and the SOS Point should be configured to make a Call Request (623 + 101) to the Control Room.
Set Call Request Forwarding:
- When dialing the event trigger number 9533, or when pressing a DAK key programmed to 9533 on the Control Room station, the following features should be activated:
- Turn on Call Request Forwarding from Control Room station 101 to station 103 (M. Larsen), so that all new call requests will be forwarded to station 103. Use the command "$SCRT" for this.
- Turn on a lamp (use RCO 3) to signal that call forwarding is active
- Write to the System LOG that the call forwarding has been activated. Use the LOG "..." statement.
Reset Call Request Forwarding:
- When dialing the event trigger number 9534, or when pressing a DAK key programmed to 9534 on the Control Room station, the following features should be activated:
- Turn off Call Request Forwarding for Control Room station 101. Use the command "$SCRT" for this.
- Turn off the lamp (RCO 3) to signal that call forwarding is not active
- Write to the System LOG that the call forwarding has been turned off. Use the LOG "..." statement.
Tip:
- Use AlphaWeb to upload a wav-file as alarm message 3, dir no 8193 (wav file is found on the memory stick)
- Use the $GM command to dispatch the message