Difference between revisions of "Flowire Software Upgrade Procedure"
From Zenitel Wiki
(→Create the special USB-Serial cable) |
(→Create the special USB-Serial cable) |
||
| Line 24: | Line 24: | ||
[[File:FlowirePins.PNG|thumb|left|500px|Flowire pinning]] | [[File:FlowirePins.PNG|thumb|left|500px|Flowire pinning]] | ||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
| + | |||
| + | |||
| + | == PC setup == | ||
| + | *Set static IP address 169.254.1.2 on your PC | ||
Revision as of 13:08, 17 April 2015
This is a step by step guide to upgrading the software in Flowire through the serial interface.
Requirements
- Windows PC
- TFTPS server, for example Tftpd32 or Tftpd64 by Ph. Jounin (http://tftpd32.jounin.net)
- Telnet software, for example PuTTY by Simon Tatham (http://www.chiark.greenend.org.uk/~sgtatham/putty/)
- Simple network switch
- 2 Ethernet cables
- Special USB-Serial cable with JTAG connector
- Flowire unit
- Flowire power supply
Create the special USB-Serial cable
- You need an RS232 cable with 3,3V TTL level. For example: http://au.element14.com/ftdi/ttl-232r-3v3/connector-type-a/dp/1329311
- Create an adapter cable to connect to the debug connector on Flowire:
Suggested type: http://no.farnell.com/harwin/m50-9011042/receptacle-to-dip-150mm-20way/dp/2289813
- On the Flowire, you must connect to these pins:
- 7: GND
- 8: UART1_TX – Connect this to Rx on the serial cable
- 16: UART1_RX – Connect this to Tx on the serial cable
PC setup
- Set static IP address 169.254.1.2 on your PC