Difference between revisions of "IP DualDisplay Connections"
From Zenitel Wiki
(Created page with "== Introduction == The table below is an overview of the main connectors involved when installing the STENTOFON IP Stations. {|border="1" |width="150px"|LAN |10/100 Mbps RJ-4...") |
(→Introduction) |
||
| Line 5: | Line 5: | ||
|width="150px"|LAN | |width="150px"|LAN | ||
|10/100 Mbps RJ-45 port for LAN (uplink) connection. Supports PoE (802.3af). Draws power from either spare line or signal line. | |10/100 Mbps RJ-45 port for LAN (uplink) connection. Supports PoE (802.3af). Draws power from either spare line or signal line. | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
|- | |- | ||
|} | |} | ||
Revision as of 10:18, 19 October 2016
Introduction
The table below is an overview of the main connectors involved when installing the STENTOFON IP Stations.
| LAN | 10/100 Mbps RJ-45 port for LAN (uplink) connection. Supports PoE (802.3af). Draws power from either spare line or signal line. |
Power Supply
The IP Station supports Power over Ethernet (PoE, IEEE 802.3 a-f) where power can be drawn from either the spare line or signal line.
If PoE is not available, the IP Station (except for IP Desktop and IP Dual Display) can be connected to a 24 VDC local power supply.
See Related Article IP Station Board Connections and Indications for local power supply connections.
Network Connection
There are two RJ45 ports on the IP Stations (except IP Dual Display):
- LAN port: for connecting to the network and the AlphaCom XE Audio Server.
- AUX port: for connecting to auxiliary equipment such as a PC or IP Camera.
There is one RJ45 port located at the bottom of the IP Dual Display station that is used as the LAN port.
|
