Difference between revisions of "SCAN RCI ONCE"
From Zenitel Wiki
(New page: {| border="1" align=left |- !style="background:#ffdead;" width="90pt" colspan="2"|SCAN_RCI_ONCE !style="background:#ffdead;" width="100pt"|0x0020 !style="background:#ffdead;" width="30pt"...) |
|||
| Line 1: | Line 1: | ||
| − | {| border="1" | + | {| border="1" |
|- | |- | ||
!style="background:#ffdead;" width="90pt" colspan="2"|SCAN_RCI_ONCE | !style="background:#ffdead;" width="90pt" colspan="2"|SCAN_RCI_ONCE | ||
| Line 20: | Line 20: | ||
|- | |- | ||
|} | |} | ||
| + | |||
| + | |||
| + | [[AlphaNet_Data_Protocol#RIO_Protocol|Back to AlphaNet message list]] | ||
Revision as of 11:50, 17 July 2007
| SCAN_RCI_ONCE | 0x0020 | 32 | AMC 05.00 | |
|---|---|---|---|---|
| $SCAN W1 U3 U5 | ||||
| Scan input until defined condition is met, then report to exchange. | ||||
| 1 | UINT2 | Input pin number | ||
| 2 | UINT1 | Scan mode: <br\>0 = Stop scan <br\>1 = Report when input is off <br\>2 = Report when input is on <br\>3 = Report when input changes (both on and off) | ||
| 3 | UINT1 | Stabilization time. Unit = 10ms. | ||
| Response: | SCAN_RCI_ACK | |||