Difference between revisions of "Ascom IP-DECT"
From Zenitel Wiki
(→Configuration of Ascom IP-DECT) |
|||
| Line 4: | Line 4: | ||
=== Configuration of Ascom IP-DECT === | === Configuration of Ascom IP-DECT === | ||
| − | Load factory default by pressing the reset button through the hole at the rear for 10 sec. | + | Load factory default by pressing the reset button through the hole at the rear with an unbend paper clip for 10 sec. |
The Ethernet port is by default set to automatically obtain an IP address (DHCP). | The Ethernet port is by default set to automatically obtain an IP address (DHCP). | ||
Revision as of 20:29, 25 September 2007
This article describes how to setup the Ascom IP-DECT to work to with the AlphaCom E using the SIP protocol.
Configuration of Ascom IP-DECT
Load factory default by pressing the reset button through the hole at the rear with an unbend paper clip for 10 sec.
The Ethernet port is by default set to automatically obtain an IP address (DHCP). In your browser, enter ipbs-xx-xx-xx, where xxxxx is the last six digits of the MAC address found at the rear of the IP Dect unit.
192.168.0.1
