WK20 - Applications: Difference between revisions
From Zenitel Wiki
| Line 24: | Line 24: | ||
2-41 | 2-41 | ||
=Amplified Calling | =Amplified Calling without answer. Amplifier switched with the M-key= | ||
[[Image:FIG WK 3 1.png|thumb|350px|Amplified Calling without answer. Amplifier switched with the M-key]] | |||
2-43 | |||
=Amplified Calling; answer in sep mic/PA constantly on 2-45= | =Amplified Calling; answer in sep mic/PA constantly on 2-45= | ||
Revision as of 15:39, 2 December 2008
Amplified Calling Tone with answer in station
Feature Description
The audio signal of incoming calls can be amplified as an extra indication of the call. The feature require a station and a separate speaker for distribution of the amplified calling tone. It is not possible to answer the call through the separate speaker.
Operation
As a call is made to the station, the corresponding RCO triggers a relay which controls the amplifier, and makes it turn on. This is repeated for every calling tone if the station is in PRIVATE position.
Equipment List
- Loudspeaker
- Power Amplifier WK1000614100
- Multi Relay Board MRBD 1009970200
Installation
Wire the components as shown on figure 1.1.
Resistor R10 needs to be removed.
Programming
Amplified Calling without answer. Amplifier constantly on
2-41
Amplified Calling without answer. Amplifier switched with the M-key
2-43