WK20 - Applications: Difference between revisions
From Zenitel Wiki
| Line 51: | Line 51: | ||
=Amplified Calling with answer in separate loudspeaker in conjunction with a station= | =Amplified Calling with answer in separate loudspeaker in conjunction with a station= | ||
==Amplifier switched with the M-key== | ==Amplifier switched with the M-key== | ||
[[Image:FIG WK 9 1.png|thumb|350px|Amplified calling with answer in separate loudspeaker in conjunction with a station. Amplifier switched with the M-key.]] | [[Image:FIG WK 9 1.png|thumb|350px|Figure 9.1: Amplified calling with answer in separate loudspeaker in conjunction with a station. Amplifier switched with the M-key.]] | ||
2-55 | 2-55 | ||
Revision as of 13:49, 3 December 2008
Amplified Calling Tone with answer in station
Feature Description
The audio signal of incoming calls can be amplified as an extra indication of the call. The feature require a station and a separate speaker for distribution of the amplified calling tone. It is not possible to answer the call through the separate speaker.
Operation
As a call is made to the station, the corresponding RCO triggers a relay which controls the amplifier, and makes it turn on. This is repeated for every calling tone if the station is in PRIVATE position.
Equipment List
- Loudspeaker
- Power Amplifier WK1000614100
- Multi Relay Board MRBD 1009970200
Installation
Wire the components as shown on figure 1.1.
Resistor R10 needs to be removed.
Programming
Amplified Calling without answer
Amplifier constantly on
2-41
Amplifier switched with the M-key
2-43
Amplified Calling with answer in separate microphone
Amplifier constantly on
2-45
Amplifier switched with the M-key
2-47
Amplified Calling; answer in sep LS/PA switched with M-key 2-49
Amplified Calling with answer in called loudspeaker
Voice direction switched with M-key
2-51
Amplifier and voice direction switched with the M-key
2-53
Amplified Calling with answer in separate loudspeaker in conjunction with a station
Amplifier switched with the M-key
2-55
