1-3c. IP Stations – SoftClient (solution)

System configuration

Install and configure the SoftClient

• Connect the IP Flush Master station to the PoE switch
• Select Setup to enter the off-line menu. Password: 1851
• Step to the menu selection IP Settings and enter the following parameters (IPgw is not relevant here):

Off-line menu: IP settings

• When prompted, Save the changes. When asked for "Restart now" you can select "No".
• Step to the menu selection AlphaCom IP and enter the following parameters:

Off-line menu: AlphaCom settings

• When prompted, Save the changes.
• Step to the menu selection Restart and activate a restart of the station

Configure the AlphaCom XE

• In AlphaPro go to Users & Stations, and select physical number 40; 140 Station 40
• Use the section on the right and change the configuration as follows:

File:1-3c solution5.png

AlphaPro: Users & Stations window

• In AlphaPro go to Users & Stations, and select physical number 38; 138 Station 38
• Use the section on the right and change the configuration as follows:

AlphaPro: Users & Stations window

• Send the changes to the AlphaCom XE

Troubleshooting

• If the IP station does not register, check the following:
  • In AlphaWeb, System Configuration -> Filters, verify that port for IP Stations and VoIP Audio is enabled
  • In AlphaWeb, System Configuration -> Licenses, verify that there are licenses installed for the SoftClient

---

Related articles

• 1-3c. IP Stations – SoftClient (practice)