Difference between revisions of "2-2d. Event Trigger - Event Handler (solution)"
From Zenitel Wiki
(→Solution) |
(→Set Call Request Forwarding:) |
||
Line 28: | Line 28: | ||
** ''Turn on a lamp (use RCO 3) to signal that call forwarding is active'' | ** ''Turn on a lamp (use RCO 3) to signal that call forwarding is active'' | ||
** ''Write to the System LOG that the call forwarding has been activated. Use the LOG "..." statement.'' | ** ''Write to the System LOG that the call forwarding has been activated. Use the LOG "..." statement.'' | ||
− | [[File:2-2d solution6.PNG|left|thumb|500px|Select the '''Control Room''' station in the list box, press '''Events''' button, and Insert a new event with parameters shown on the screen shot.]] | + | [[File:2-2d solution6.PNG|left|thumb|500px|Select the '''Control Room''' station in the list box, press '''Events''' button, and '''Insert''' a new event with parameters shown on the screen shot.]] |
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
− | |||
====Reset Call Request Forwarding:==== | ====Reset Call Request Forwarding:==== |
Revision as of 16:44, 6 November 2013
Contents
Solution
Call setup:
- The Entrance and the SOS Point should be configured to make a Call Request (623 + 101) to the Control Room.
- The Control Room should be configured as a CRM (Control Room Master), the DAK display should be enabled, and the Navigation Keys should be used for call queue navigations.
Set Call Request Forwarding:
- When dialing the event trigger number 9533, or when pressing a DAK key programmed to 9533 on the Control Room station, the following features should be activated:
- Turn on Call Request Forwarding from Control Room station 101 to station 103 (M. Larsen), so that all new call requests will be forwarded to station 103. Use the command "$SCRT" for this.
- Turn on a lamp (use RCO 3) to signal that call forwarding is active
- Write to the System LOG that the call forwarding has been activated. Use the LOG "..." statement.
Reset Call Request Forwarding:
- When dialing the event trigger number 9534, or when pressing a DAK key programmed to 9534 on the Control Room station, the following features should be activated:
- Turn off Call Request Forwarding for Control Room station 101. Use the command "$SCRT" for this.
- Turn off the lamp (RCO 3) to signal that call forwarding is no longer active
- Write to the System LOG that the call forwarding has been turned off. Use the LOG "..." statement.