Difference between revisions of "2-2d. Event Trigger - Event Handler (solution)"
From Zenitel Wiki
(→Reset Call Request Forwarding:) |
(→Reset Call Request Forwarding:) |
||
Line 41: | Line 41: | ||
Program DAK 1 and DAK 2 of the Control Room station with the codes for Call Forwarding on (9533) and Call Forwarding off (9534), and add an appropriate display text. | Program DAK 1 and DAK 2 of the Control Room station with the codes for Call Forwarding on (9533) and Call Forwarding off (9534), and add an appropriate display text. | ||
− | [[File:2-2d solution5.PNG|left|thumb|500px|Select the '''Control Room''' station in the list box, press '''DAK''' button, select the "''' | + | [[File:2-2d solution5.PNG|left|thumb|500px|Select the '''Control Room''' station in the list box, press '''DAK''' button, select the "'''DAK 1-10'''" tab, and enter 9533 T <text> and 9534 T <text> on DAK key 1 and 2]] |
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
Revision as of 16:55, 6 November 2013
Contents
Solution
Call setup:
- The Entrance and the SOS Point should be configured to make a Call Request (623 + 101) to the Control Room.
- The Control Room should be configured as a CRM (Control Room Master), the DAK display should be enabled, and the Navigation Keys should be used for call queue navigations.
Set Call Request Forwarding:
- When dialing the event trigger number 9533, or when pressing a DAK key programmed to 9533 on the Control Room station, the following features should be activated:
- Turn on Call Request Forwarding from Control Room station 101 to station 103 (M. Larsen), so that all new call requests will be forwarded to station 103. Use the command "$SCRT" for this.
- Turn on a lamp (use RCO 3) to signal that call forwarding is active
- Write to the System LOG that the call forwarding has been activated. Use the LOG "..." statement.
Reset Call Request Forwarding:
- When dialing the event trigger number 9534, or when pressing a DAK key programmed to 9534 on the Control Room station, the following features should be activated:
- Turn off Call Request Forwarding for Control Room station 101. Use the command "$SCRT" for this.
- Turn off the lamp (RCO 3) to signal that call forwarding is no longer active
- Write to the System LOG that the call forwarding has been turned off. Use the LOG "..." statement.
Program DAK 1 and DAK 2 of the Control Room station with the codes for Call Forwarding on (9533) and Call Forwarding off (9534), and add an appropriate display text.