|
|
| Line 1: |
Line 1: |
| − | == Introduction ==
| + | {{APS}} |
| − | The table below is an overview of the main connectors involved when installing the IP DualDisplay Station. | + | The IP DualDisplay station has one ethernet port: |
| | | | |
| − | {|border="1"
| + | * '''LAN''': 10/100 Mbps RJ-45 port for '''connection to the network'''. Supports Power Over Ethernet - PoE (802.3af). Draws power from either the spare pairs or from the signal line. |
| − | |width="150px"|LAN
| |
| − | |10/100 Mbps RJ-45 port for LAN (uplink) connection. Supports PoE (802.3af). Draws power from either spare line or signal line.
| |
| − | |-
| |
| − | |}
| |
| − | | |
| − | == Power Supply ==
| |
| − | The IP Station supports Power over Ethernet (PoE, IEEE 802.3 a-f) where power can be drawn from either the spare line or signal line.
| |
| − | | |
| − | == Network Connection ==
| |
| − | There is one RJ45 port located at the bottom of the IP Dual Display station that is used as the LAN port.
| |
| | | | |
| | [[Image:IP_DualDisplay_Bottom_View.PNG|left|thumb|300px|IP Dual Display - Bottom view]] | | [[Image:IP_DualDisplay_Bottom_View.PNG|left|thumb|300px|IP Dual Display - Bottom view]] |
Revision as of 15:42, 16 March 2017
The IP DualDisplay station has one ethernet port:
- LAN: 10/100 Mbps RJ-45 port for connection to the network. Supports Power Over Ethernet - PoE (802.3af). Draws power from either the spare pairs or from the signal line.
IP Dual Display - Bottom view
