Automatic M-key In Group Call: Difference between revisions

Revision as of 14:07, 20 May 2022

A Group Call can be configured to start audio without the need of pressing the M-key. This is configurable for each individual group. The setting is available from AlphaPro.

M-key options for group call

0 = Regular group call behaviour, e.g. M-key must be pressed to open the audio path
1 = Automatic M-key for all stations initiating the group call
2 = Automatic M-key when SIP stations are initiating the group call

Additional information

Automatic M-key is meant to be used on SIP or special non display stations.
Automatic M-key will on AlphaCom display stations show "wait" in second line of the display.
Require AMC software 10.30 or later

Back to Feature description

@@ Line 12: / Line 12: @@
 </table>
-== From the TST console==
- TST>>nvram - ex_profile.group[1].flags = 1 (0x01)
-Flags:<br />
 = Regular group call behaviour, e.g. M-key must be pressed to open the audio path <br />
 = Automatic M-key for all stations initiating the group call <br />
 = Automatic M-key when SIP stations are initiating the group call<br />
-== Configuration from Event Handler ==
-[[Image:Automatic M-key for Group Calls.jpg|thumb|right|Enable automatic M-key for group 3 (86) when called from SIP]]
-The [[System_Status_%28Event_Type%29 | System Status Event]] related to device 65 will be triggered when the AlphaCom starts up. Use the following action string:
- $[[SNV]] Q('''flag''') W1 W11 W('''group number''') W6
-'''flag''' = 0, 1 or 2 as described above<br>
-'''group number''' = 1 - 100
-The programming will take effect after a reset of the exchange.
 ==Additional information ==

Automatic M-key In Group Call: Difference between revisions

From Zenitel Wiki

Revision as of 14:07, 20 May 2022

Additional information