Automatic Gain Control (AGC)

This article is under construction!

Zenitel IP devices supports Automatic Gain Control (AGC). The purpose of the AGC feature ..............

Default active???

Not config in TCIV+?

---

Mic Automatic Gain Control

Config Currently only for VSFT/imx28 devices. VSFF/imx6 and imx8 have "Fixed Mic Automatic Gain Control", see below

To be used with caution and in special conditions where Near-End talker may be operating in varying distances deviating from the nominal talker distance to the station.

IC-Edge mode

Log in to the Edge Controller, and navigate to Edge Controller > System Configuration > Call and Audio, and enable "AGC":

Enabling AGC in an IC-Edge system

SIP and ICX-AlphaCom mode

Log in to the Zenitel IP device.

• SIP mode: Navigate to SIP Configuration > Audio Settings, and enable "Automatic Gain Control (AGC)"
• ICX-AlphaCom mode: Navigate to Advanced ICX-AlphaCom > Audio Settings, and enable "Automatic Gain Control (AGC)"

Enabling AGC on a device in SIP or ICX-AlphaCom mode (screenshot from firmware 7 and later)

Some additional settings are available in Advanced Configuration mode. Navigate to Audio Settings > Audio signal processing:

Advanced AGC settings (screenshot from firmware 7 and later)

• Enable AGC: Enable/disable the AGC component which brings the microphone signal to an appropriate range
• AGC mode: Algorithm type. Use Digital SW AGC for the majority of use cases. Analouge HW AGC is available only on Turbine devices using analogue microphone. "Analogue HW AGC" should basically be used for "Push to Talk"/"Talk back" applications and not in Open Duplex modes
  • Digital SW AGC
  • Analouge HW AGC (noisy profile)
  • Analouge HW AGC (quiet profile)
• AGC gain profile: Extent level of added gain. The target signal gain level. "Standard" shall aim to keep a "nominal voice signal level" at approx -23 dBFS. The other options will target increasingly higher signal levels. Use with caution.
  • Standard
  • Moderate
  • High
  • Very high
• AGC speed: Attack and decay rates of the algorithm.
  • Slow
  • Fast