|
|
| Line 11: |
Line 11: |
| |- | | |- |
| |1 - 64 || 0x01 - 0x40 || External boxes. RIOs, PCs etc. | | |1 - 64 || 0x01 - 0x40 || External boxes. RIOs, PCs etc. |
| |-
| |
| | [[SET_RCO]] || Turn the given remote control output on
| |
| |-
| |
| | [[SET_RCO_OK]] || Positive response to the SET_RCO message
| |
| |-
| |
| | [[SET_RCO_FAILED]] || Negative response to the SET_RCO message
| |
| |-
| |
| | [[CLEAR_RCO]] || Turn the given remote control output off
| |
| |-
| |
| | [[CLEAR_RCO_OK]] || Positive response to the CLEAR_RCO message
| |
| |-
| |
| | [[CLEAR_RCO_FAILED]] || Negative response to the CLEAR_RCO message
| |
| |-
| |
| | [[PULSE_RCO]] || Generate a pulse with the defined length
| |
| |-
| |
| | [[PULSE_RCO_OK]] || Positive response to the PULSE_RCO message
| |
| |-
| |
| | [[PULSE_RCO_FAILED]] || Negative response to the PULSE_RCO message
| |
| |-
| |
| | [[POLL_RCI]] || Poll the given remote control input once
| |
| |-
| |
| | [[SCAN_RCI_ONCE]] || Scan input until defined condition is met, then report to exchange
| |
| |-
| |
| | [[SCAN_RCI_ACK]] || Positive response to the SCAN_RCI_ONCE message
| |
| |-
| |
| | [[RCI_IS_ON]] || Response to the POLL_RCI and SCAN_RCI_ONCE messages, input pin is on
| |
| |-
| |
| | [[RCI_IS_OFF]] || Response to the POLL_RCI and SCAN_RCI_ONCE messages, input pin is off
| |
| |-
| |
| | [[SCAN_END_ACK]] || Acknowledgment to the RCI_IS_OFF and RCI_IS_ON messages
| |
| |- | | |- |
| |} | | |} |
Revision as of 22:12, 19 June 2007
All data messages are addressed to a device. A device is always related to (owned by) a node. A full device address consists of <node> <device>.
<Device> is one byte.
Note that devices can both be physical boxes (e.g. RIO) or a function (Router).
| Value (decimal)
|
Value (Hex)
|
Device Function
|
| 0 |
0x00 |
Invalid device (reserved NULL value)
|
| 1 - 64 |
0x01 - 0x40 |
External boxes. RIOs, PCs etc.
|
