Difference between revisions of "ATLB - AlphaCom Telephone Line Board"
From Zenitel Wiki
Line 1: | Line 1: | ||
{{stub}} | {{stub}} | ||
[[image:ATLB Telephone Line Board.jpg|thumb|100px|ATLB Telephone Line Board]] | [[image:ATLB Telephone Line Board.jpg|thumb|100px|ATLB Telephone Line Board]] | ||
+ | == Features == | ||
+ | * Is used for 2-wire connection of telephones as stations in an AlphaCom system | ||
+ | * Each board provides 6 telephone connections and 1 voice-switched conversation | ||
+ | * 6 remote control outputs (software configurable activation) | ||
+ | * Hotline function | ||
+ | * DTMF dialing | ||
+ | * R-button detection | ||
+ | * Selectable -48V or -24V battery feed | ||
+ | * 600 ohm or complex impedance hybrid balance | ||
+ | * Line monitoring using resistor in parallel with phone | ||
+ | * Hot plug in and out of the board | ||
+ | * Red/green/amber LED indicates system status | ||
+ | * Different types of connection boards available | ||
+ | |||
+ | == Description == | ||
+ | This board contains circuitry for connection of 6 2-wire | ||
+ | telephones as AlphaCom subscribers. The board also | ||
+ | provides one measurement channel for voice switching | ||
+ | control. It plugs into any position 1 - 23. | ||
+ | |||
+ | When the hot-line function is activated for the station a | ||
+ | preprogrammed number is dialed when the handset is | ||
+ | lifted. When the handset is replaced, another number is | ||
+ | dialed. | ||
+ | |||
+ | The board provides 6 remote control outputs that are | ||
+ | software-controlled. The line monitoring reports errors | ||
+ | on all subscriber lines. If the handset is left off for 1 | ||
+ | hour (programmable timer) a line error is reported. | ||
+ | |||
+ | The board can be plugged in/out while the exchange is | ||
+ | running. A hot plug-in cable is needed for this purpose. | ||
+ | The cable is included in the cable set for the exchange. | ||
[[Category:AlphaCom E System]] | [[Category:AlphaCom E System]] |
Revision as of 13:15, 25 June 2007
Features
- Is used for 2-wire connection of telephones as stations in an AlphaCom system
- Each board provides 6 telephone connections and 1 voice-switched conversation
- 6 remote control outputs (software configurable activation)
- Hotline function
- DTMF dialing
- R-button detection
- Selectable -48V or -24V battery feed
- 600 ohm or complex impedance hybrid balance
- Line monitoring using resistor in parallel with phone
- Hot plug in and out of the board
- Red/green/amber LED indicates system status
- Different types of connection boards available
Description
This board contains circuitry for connection of 6 2-wire telephones as AlphaCom subscribers. The board also provides one measurement channel for voice switching control. It plugs into any position 1 - 23.
When the hot-line function is activated for the station a preprogrammed number is dialed when the handset is lifted. When the handset is replaced, another number is dialed.
The board provides 6 remote control outputs that are software-controlled. The line monitoring reports errors on all subscriber lines. If the handset is left off for 1 hour (programmable timer) a line error is reported.
The board can be plugged in/out while the exchange is running. A hot plug-in cable is needed for this purpose. The cable is included in the cable set for the exchange.