Difference between revisions of "TST console"
From Zenitel Wiki
(→over Serial Port) |
|||
Line 27: | Line 27: | ||
::*PC serial port setting: 9600 baud, 8 data bits, no parity, 1 stop bit | ::*PC serial port setting: 9600 baud, 8 data bits, no parity, 1 stop bit | ||
[[Image:TST Console – over Serial Port.jpg|left|600px|thumb]] | [[Image:TST Console – over Serial Port.jpg|left|600px|thumb]] | ||
+ | |||
+ | |||
+ | == Start and Stop == | ||
+ | |||
+ | *TST Activation Code: #SERVICE* (no echo) | ||
+ | :- Response on VDU: TST-TARGET>> | ||
+ | :- New log-on required after reset | ||
+ | |||
+ | *Stop TST: | ||
+ | :- Type bye, or | ||
+ | :- Reset exchange | ||
+ | :- If not stopped properly, AlphaPro will not communicate |
Revision as of 13:27, 5 July 2007
General
- Part of the AlphaCom Software
- Debugging tool for software development
- Direct access to the AMC NVRAM memory
- Can be useful for troubleshooting
- TST Console uses a simple terminal interface
- - PC with terminal emulator (such as Hyper Terminal)
over IP
- TST Console via IP
- - Create a new connection in HyperTerminal
- - Host adress = IP-address of the AMC board
- - Port number must be 60001 (AlphaPro port)
- - When connecting you will be promped for username and password (admin + alphaadmin)
<br\><br\><br\><br\><br\><br\><br\><br\><br\><br\><br\>
over Serial Port
- TST Console via serial port
- - Enable AlphaPro on Serial port 0: S601-1 ON
- - Connect the PC com port to AlphaCom serial port 0
- - Start Windows HyperTerminal
- PC serial port setting: 9600 baud, 8 data bits, no parity, 1 stop bit
Start and Stop
- TST Activation Code: #SERVICE* (no echo)
- - Response on VDU: TST-TARGET>>
- - New log-on required after reset
- Stop TST:
- - Type bye, or
- - Reset exchange
- - If not stopped properly, AlphaPro will not communicate