Difference between revisions of "Ascom IP-DECT"
From Zenitel Wiki
| Line 1: | Line 1: | ||
| + | This article describes.... | ||
| + | |||
| + | === Configuration of Ascom IP-DECT === | ||
Load factory default by pressing the reset button through the hole at the rear for 10 sec. | Load factory default by pressing the reset button through the hole at the rear for 10 sec. | ||
| Line 42: | Line 45: | ||
[[Image:Ascom registration.jpg|thumb|Successful registration]] | [[Image:Ascom registration.jpg|thumb|Successful registration]] | ||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
| + | |||
| + | === Configuration of AlphaCom E === | ||
| + | |||
Revision as of 14:50, 25 September 2007
This article describes....
Configuration of Ascom IP-DECT
Load factory default by pressing the reset button through the hole at the rear for 10 sec.
The Ethernet port is by default set to automatically obtain an IP address (DHCP). In your browser, enter ipbs-xx-xx-xx, where xxxxx is the last six digits of the MAC address found at the rear of the IP Dect unit.
192.168.0.1
