Difference between revisions of "Ascom IP-DECT"
From Zenitel Wiki
(→Configuration of Ascom IP-DECT) |
(→Configuration of Ascom IP-DECT) |
||
| Line 4: | Line 4: | ||
=== Configuration of Ascom IP-DECT === | === Configuration of Ascom IP-DECT === | ||
| − | Load factory default configuration on the IP | + | Load factory default configuration on the IP-Dect unit by pressing the reset button through the hole at the rear with an unbend paper clip for 10 sec. |
| − | The Ethernet port is by default set to obtain an IP address automatically (DHCP). | + | The Ethernet port is by default set to obtain an IP address automatically (DHCP) if connected to a LAN network with DHCP server. Then simply start your internet browser, in the address field enter '''ipbs-xx-xx-xx''', where xx-xx-xx is the last six digits of the MAC address printed at the rear of the IP-Dect unit. |
| − | |||
192.168.0.1 | 192.168.0.1 | ||
Revision as of 20:34, 25 September 2007
This article describes how to setup the Ascom IP-DECT to work to with the AlphaCom E using the SIP protocol.
Configuration of Ascom IP-DECT
Load factory default configuration on the IP-Dect unit by pressing the reset button through the hole at the rear with an unbend paper clip for 10 sec.
The Ethernet port is by default set to obtain an IP address automatically (DHCP) if connected to a LAN network with DHCP server. Then simply start your internet browser, in the address field enter ipbs-xx-xx-xx, where xx-xx-xx is the last six digits of the MAC address printed at the rear of the IP-Dect unit.
192.168.0.1
