WK20 - Applications: Difference between revisions
From Zenitel Wiki
| Line 40: | Line 40: | ||
=Amplified Calling; answer in sep LS/PA switched with M-key 2-49= | =Amplified Calling; answer in sep LS/PA switched with M-key 2-49= | ||
=Amplified Calling | =Amplified Calling with answer in called Loudspeaker= | ||
==Voice direction switched with M-key== | |||
[[Image:FIG WK 7 1.png|thumb|350px|Amplified Calling with answer in called loudspeaker. Voice direction switched with M-key]] | |||
2-51 | |||
=Amplified Calling; answer in call LS/amp and voice direction switched w/M-key 2-53= | =Amplified Calling; answer in call LS/amp and voice direction switched w/M-key 2-53= | ||
Revision as of 11:18, 3 December 2008
Amplified Calling Tone with answer in station
Feature Description
The audio signal of incoming calls can be amplified as an extra indication of the call. The feature require a station and a separate speaker for distribution of the amplified calling tone. It is not possible to answer the call through the separate speaker.
Operation
As a call is made to the station, the corresponding RCO triggers a relay which controls the amplifier, and makes it turn on. This is repeated for every calling tone if the station is in PRIVATE position.
Equipment List
- Loudspeaker
- Power Amplifier WK1000614100
- Multi Relay Board MRBD 1009970200
Installation
Wire the components as shown on figure 1.1.
Resistor R10 needs to be removed.
Programming
Amplified Calling without answer
Amplifier constantly on
2-41
Amplifier switched with the M-key
2-43
Amplified Calling with answer in separate microphone
Amplifier constantly on
2-45
Amplifier switched with the M-key
2-47
Amplified Calling; answer in sep LS/PA switched with M-key 2-49
Amplified Calling with answer in called Loudspeaker
Voice direction switched with M-key
2-51