IP Desktop Station with Video Display - 1408001635
From Zenitel Wiki
Contents
- 1 Requirements
- 2 Limitations
- 3 Configuration
- 4 Dimensions
- 5 Reset to factory settings
- 6 Additional Documentation on Zenitel.com
- 7 Getting Started
- 8 Configuration
- 9 Advanced Network Settings
- 10 Restore Factory Defaults and Software Upgrade
- 11 Connectors, Indicators and Dimensions
- 12 Accessories
- 13 Related information
Requirements
Software requirements
- The IP Video Display requires the IP Desktop Station to run software version 02.04.1.12 or newer
- AMC-IP Software requirements: Version 11.2.3.4 or newer
Camera requirements
- Video codec: MJPG only
- Resolution: 240x320
Limitations
Video is not shown when receiving a Call Request, or when called via a Ringing group. After answering the call, video will be shown.
Configuration
- IP Station Configuration
- VLAN (IEEE 8021Q)
- Network Access Control (802.1X)
- Noise Reduction
- Video Display Configuration
- Voice Activity Detection (VAD)
Dimensions
Reset to factory settings
Additional Documentation on Zenitel.com
Getting Started
Configuration
The station can operate in three different modes, depending on what kind of server the station should register to. Choose one of the links below according to what mode you need to configure.
- IP Station Configuration - AlphaCom mode
- IP Station Configuration - SIP mode
- IP Station Configuration - Pulse mode
- IP Desktop - Video Module Configuration
Advanced Network Settings
Restore Factory Defaults and Software Upgrade
- Reset the intercom station to factory default settings
- Reset the Video Module to factory default settings
- Software Upgrade
- Software Upgrade of the Video Module
- Automatic Software Upgrade (SIP mode only)