Pelco Digital Sentry and CP-CAM
From Zenitel Wiki
Introduction
CP-CAM, the camera in the IP Video Door Station 1401110100, can also be used with Pelco's Digital Sentry.
Digital Sentry
Digital Sentry supports most camera manufacturer with some pre-programmed parameters. But DS also offers the selection possibility 'Other'.
- Click 'Add IP Camera' and select 'Other'
- Set the IP address of the camera in the 'IP Configuration' section
- Under 'Custom URL' program the complete URL, for instance: http://169.254.1.101/mjpg/video.mjpg
- If the camera has been set up to authentication, enter the correct Username and Password
Programming frame rate and resolution in the Digital Sentry camera setup dialog has no influence, CP-CAM does not accept these settings as part of the connection URL. The frame rate and resolution as set on the CP-CAM web page will be used.
Integration of ICX or AlphaCom with Digital Sentry
For integration between ICX or AlphaCom and Digital Sentry see the article Pelco Digital Sentry - ICX-AlphaCom integration