IP-ARIO Connections
From Zenitel Wiki
Installation
The table below is an overview of the main connections involved when installing the IP-ARIO unit.
| LAN | 10/100 Mbps RJ45 port for LAN (uplink) connection. Supports PoE (802.3af). Draws power from either spare line or signal line. |
| AUX | 10/100 Mbps RJ45 port for auxiliary equipment such as PC and IP camera. |
| RS232 | RJ45 port (pinout: 3=TX, 4&5=GND, 6=RX) |
| PA Interface | Dual Balanced 600 Ohm 0dB audio out (adjustable 0 to -10 dB) |
| Radio Interface | Single 600 Ohm 0dB audio in/out (adjustable 0 to -10 dB) |
| Digital Inputs | 8 inputs (Input 1 and 2 is referred to GND, input 3 to 8 is shorting or referred to GND) |
| Digital Outputs | 8 relay outputs (Output 1 - 4 is closing contact, output 5 - 8 is change-over contact). 60W switching capacity |
| Local Power | Pluggable screw terminal, 19-27 VDC Idle 4W, max. 8W |
Power Supply
The IP-ARIO unit supports Power over Ethernet (PoE,IEEE 802.3af) where power can be drawn from either the spare or signal line. If PoE is not available, the IP-ARIO unit can be connected to a local power supply of 24 VDC.
Network Connection
There are three RJ45 ports at the rear of the IP-ARIO unit:
- LAN port is for connecting to the network and the AlphaCom server/exchange.
- AUX port is for connecting to auxiliary equipment such as a PC.
- RS 232 port is for remote signalling