STIC

STIC - STENTOFON Identity Card

STIC - STENTOFON Identity Card

What is the STIC

The STENTOFON Identity Card is the logical identity of the AMC-IP board. The STIC contains the unique network identifier (MAC address) and network settings for the AMC-IP board, making it possible to replace the AMC-IP without any reprogramming of the system. Just move the STIC from the old AMC-IP to the new one.

The STIC is based on SmartCard technology, which also is used in modern credit cards. This technology is well tested and proven to be extremly reliable.

How to use the STIC

The STENTOFON AMC-IP card (of revision 11 and later) is equipped with a SIM sized SmartCard holder. When delivered, the STIC is in a regular credit card size, and the smaller SIM resides within it. The smaller SIM card must be loosened by gently pressing it out.

Different types of STIC

There are two types of STIC:

• Small audio servers (XE1 & XE7)
• Large audio servers (XE20 & XE26)

Note: The STIC for the small audio servers can only be used in an XE1 or an XE7 audio server. If such a STIC is inserted into a large audio server XE20 or XE26, the server will be operational for 15 minuttes, then all operations will be blocked. During the operational period, all display stations will show "STIC ERR3(xxM)", indicating xx minutes of operational time left. AlphaWeb will show "Illegal STIC for XE20/XE26"

The STIC for the large audio servers can also be used in the small audio servers.

Important information

Do not attempt to remove the STIC from the AMC-IP while the system is powered up. If the AMC-IP detects that no STIC is present, it will go into an alert mode for 1 week. After 1 week, if no STIC is present, the entire audio server will be reset and kept in reset until a valid STIC is inserted.

Lost STICs will not be replaced by Zenitel. The STIC will be replaced by Zenitel only if it is not functioning.

Ordering

When ordering an Audio Server the STIC will be a part of the package together with the AMC-IP board. If a spare AMC-IP board is ordered the STIC must be ordered separately. This is because that if the spare AMC-IP board v11 is to replace a faulty AMC-IP board v11, then it will already have a STIC which can be inserted into the new board.

Minimum requirements

The STIC requires alphasys 11.1.3.x in order to run correctly. A cold start is also required to enable the AMC board to read the STIC fully.