Ascom IP-DECT

This article describes how to setup the SIP based Ascom IP-DECT to work to with the AlphaCom E.

Configuration example

Configuration of Ascom IP-DECT

Load factory default by pressing the reset button through the hole at the rear for 10 sec.

The Ethernet port is by default set to automatically obtain an IP address (DHCP). In your browser, enter ipbs-xx-xx-xx, where xxxxx is the last six digits of the MAC address found at the rear of the IP Dect unit.

192.168.0.1

Ascom Webserver - Log on

Switch DHCP off

Set IP address

Setup of Dect base

Configure master base

Base setup

Enter SARI

Set base sync mode

Add a new user

Show all users

Successful registration

Related articles

Test report Ascom IP-Dect