Ascom IP-DECT

This article describes how to setup the Ascom IP-DECT to work to with the AlphaCom E using the SIP protocol.

Configuration example

Configuration of Ascom IP-DECT

Load factory default configuration on the IP-Dect unit by pressing the reset button through the hole at the rear with an unbend paper clip for 10 sec.

The Ethernet port is by default set to obtain an IP address automatically (DHCP) if connected to a LAN network with DHCP server. Then simply start your internet browser, in the address field enter ipbs-xx-xx-xx, where xx-xx-xx is the last six digits of the MAC address printed at the rear of the IP-Dect unit.

192.168.0.1

Ascom Webserver - Log on

Switch DHCP off

Set IP address

Setup of Dect base

Configure master base

Base setup

Enter SARI

Set base sync mode

Add a new user

Show all users

Successful registration

Related articles

Test report Ascom IP-Dect