WK20 - Applications
From Zenitel Wiki
Contents
- 1 Amplified Calling Tone with answer in station
- 2 Amplified Calling without answer
- 3 Amplified Calling with answer in separate microphone
- 4 Amplified Calling; answer in sep LS/PA switched with M-key 2-49
- 5 Amplified Calling with answer in called Loudspeaker
- 6 Amplified Calling with answer in separate loudspeaker in conjunction with a station
- 7 Amplified Calling with answer in called loudspeaker in conjunction with a station
Amplified Calling Tone with answer in station
Feature Description
The audio signal of incoming calls can be amplified as an extra indication of the call. The feature require a station and a separate speaker for distribution of the amplified calling tone. It is not possible to answer the call through the separate speaker.
Operation
As a call is made to the station, the corresponding RCO triggers a relay which controls the amplifier, and makes it turn on. This is repeated for every calling tone if the station is in PRIVATE position.
Equipment List
- Loudspeaker
- Power Amplifier WK1000614100
- Multi Relay Board MRBD 1009970200
Installation
Wire the components as shown on figure 1.1.
Resistor R10 needs to be removed.
Programming
Amplified Calling without answer
Amplifier constantly on
2-41
Amplifier switched with the M-key
2-43
Amplified Calling with answer in separate microphone
Amplifier constantly on
2-45
Amplifier switched with the M-key
2-47
Amplified Calling; answer in sep LS/PA switched with M-key 2-49
Amplified Calling with answer in called Loudspeaker
Voice direction switched with M-key
2-51
Amplifier and voice direction switched with M-key
2-53
Amplified Calling with answer in separate loudspeaker in conjunction with a station
Amplifier switched with the M-key
2-55
