1-3c. IP Stations – SoftClient (solution)

System configuration

Install and configure the SoftClient

• Download the file SoftClientSetup.msi from e.g. AlphaWiki or from Partnernet, and install it on the PC
• Change the IP address of the PC to 10.1.10.2, and subnet mask 255.255.0.0
• Start the SoftClient, and select File -> Preferences, and set these parameters:

File:1-3c solution1.png

Off-line menu: IP settings

• When prompted, Save the changes. When asked for "Restart now" you can select "No".
• Step to the menu selection AlphaCom IP and enter the following parameters:

Off-line menu: AlphaCom settings

• When prompted, Save the changes.
• Step to the menu selection Restart and activate a restart of the station

Configure the AlphaCom XE

• In AlphaPro go to Users & Stations, and select physical number 40; 140 Station 40
• Use the section on the right and change the configuration as follows:

File:1-3c solution5.png

AlphaPro: Users & Stations window

• In AlphaPro go to Users & Stations, and select physical number 38; 138 Station 38
• Use the section on the right and change the configuration as follows:

AlphaPro: Users & Stations window

• Send the changes to the AlphaCom XE

Troubleshooting

• If the SoftClient does not register, check the following:
  • In AlphaWeb, System Configuration -> Filters, verify that port for IP Stations and VoIP Audio is enabled
  • In AlphaWeb, System Configuration -> Licenses, verify that there are licenses installed for the SoftClient

---

Related articles

• 1-3c. IP Stations – SoftClient (practice)