2-2d. Event Trigger - Event Handler (practice)

This article is a stub. You can help AlphaWiki by expanding it.

System configuration

Call setup:

The Entrance and the SOS Point should be configured to make a Call Request (623 + 101) to the Control Room.

Set Call Request Forwarding:

When dialing the event trigger number 9533, or when pressing a DAK key programmed to 9533 on the Control Room station, the following features should be activated:
- Turn on Call Request Forwarding from Control Room station 101 to station 103 (M. Larsen), so that all new call requests will be forwarded to station 103. Use the command "$SCRT" for this.
- Turn on a lamp (use RCO 3) to signal that call forwarding is active
- Write to the System LOG that the call forwarding has been activated. Use the LOG "..." statement.

Reset Call Request Forwarding:

When dialing the event trigger number 9534, or when pressing a DAK key programmed to 9534 on the Control Room station, the following features should be activated:
- Turn off Call Request Forwarding for Control Room station 101. Use the command "$SCRT" for this.
- Turn off the lamp (RCO 3) to signal that call forwarding is not active
- Write to the System LOG that the call forwarding has been turned off. Use the LOG "..." statement.

Tip:

Use AlphaWeb to upload a wav-file as alarm message 3, dir no 8193 (wav file is found on the memory stick)
Use the $GM command to dispatch the message