IP Master Station -V2 Restore Factory Defaults
From Zenitel Wiki
This procedure is the recommended procedure for all IP Stations with Display.
- The Station Menu is available in both Edge and SIP mode.
- In ICX-Alphacom mode the Station Menu is only available when the IP Station is offline mode. i.e. not registered to the server.
Contents
Procedure
- Press the Setup button beneath the display
- Enter the password 1851 and press the Ok button.
- Navigate to Load defaults and press the Sel button.
- Press the Sel button to load factory defaults.
Factory default values
The station will now restart with factory settings:
- Station IP address: Determined by DHCP server. If no DHCP server is available, it gets a random 169.254.x.x address.
- Username: admin
- Password: alphaadmin
- Mode of operation: Edge
Alternative procedure
|
IP Desktop with handset can also perform the procedure by lifting the handset offhook instead of pressing a DAK. |
Reset to Factory Default Settings with Activated DHCP
To reset:
- 1. While pressing any button, power up the station by connecting it to a PoE switch.
- 2. Hold the button until the station audio starts counting, and release the button on count 1.
- 3. Press and hold the button on count 5 and release on count 0.
- - if there is no 0 count, the procedure has failed and you have to start again
- 4. Press M button or any DAK, and the station will speak its IP address
Reset to Factory Default Settings with Static IP
To reset:
- 1. While pressing any button, power up the station by connecting to a PoE switch.
- 2. Hold the button until the station audio starts counting, and release the button on count 1.
- 3. Press and hold the button on count 3 and release on count 0.
- - if there is no 0 count, the procedure has failed and you have to start again
- 4. Press M button or any DAK, and the station will speak its IP address
