Automatic Gain Control (AGC)

This article is under construction!

Zenitel IP devices supports Automatic Gain Control (AGC). The purpose of the AGC feature ..............

Default active???

Not config in TCIV+?

Log in to the Edge Controller, and navigate to Edge Controller > System Configuration > Call and Audio, and enable "AGC":

Enabling AGC in an IC-Edge system

Log in to the Zenitel IP device.

SIP mode: Navigate to SIP Configuration > Audio Settings, and enable "Automatic Gain Control (AGC)"
ICX-AlphaCom mode: Navigate to Advanced ICX-AlphaCom > Audio Settings, and enable "Automatic Gain Control (AGC)"

Enabling AGC on a device in SIP or ICX-AlphaCom mode (screenshot from firmware 7 and later)

Some additional settings are available in Advanced Configuration mode. Navigate to Audio Settings > Audio signal processing:

Advanced AGC settings (screenshot from firmware 7 and later)

Enable AGC: Check the box to enable automatic volume control. Volume is adjusted according to the ambient noise level. The AVC will perform better if the loudspeaker volume is set to a fairly low level, as this will give the AVC a more dynamic range for adjustments. Note that the AVC adjustment is disabled while the speaker is playing audio. Adjustments are made in silent periods (min. 100 ms silence required).
Debug in Display: When enabled the station shows current volume level in the OLED display (applicable to TCIS-4, TCIx-5 and TCIx-6 stations)
AGC mode: Check to open for more advanced AVC settings
AGC gain profile: Threshold level for the AVC to start working. Valid range: 30-80 dBA. Default is 55 dBA.
- AGC speed: Threshold level for the AVC to stop working. Valid range: 60-120 dBA. Default is 100 dBA.