Difference between revisions of "1-1a. Exchange startup (solution)"
From Zenitel Wiki
(Created page with "Text... ===Related articles === * Exchange startup (practice) Category: AlphaCom practice") |
|||
| Line 1: | Line 1: | ||
| − | + | [[File:EX1-1a.PNG|400px|thumb]] | |
| + | |||
| + | ==Practice 1-1a:== | ||
| + | |||
| + | ===Cards:=== | ||
| + | *Insert the two ASLT cards in position 1 and 2. | ||
| + | *Insert the AMC-IP card in position 7. | ||
| + | |||
| + | ===Power:=== | ||
| + | *Connect the power source to the plug on the back of the exchange, marked ''24 VAC IN'' | ||
| + | *Connect the mains cable to the wall outlet | ||
| + | *Observe the exchange starting | ||
| + | |||
| + | ===Coldstart:=== | ||
| + | *Press and hold the coldstart button on the AMC-IP board | ||
| + | *Press the reset button on the power card briefly | ||
| + | *Keep the cold start button pressed at least 2 sec. after reset. | ||
| + | *The AMC status LED will blink green when the boot is ready. | ||
===Related articles === | ===Related articles === | ||
Revision as of 23:50, 26 February 2011
Practice 1-1a:
Cards:
- Insert the two ASLT cards in position 1 and 2.
- Insert the AMC-IP card in position 7.
Power:
- Connect the power source to the plug on the back of the exchange, marked 24 VAC IN
- Connect the mains cable to the wall outlet
- Observe the exchange starting
Coldstart:
- Press and hold the coldstart button on the AMC-IP board
- Press the reset button on the power card briefly
- Keep the cold start button pressed at least 2 sec. after reset.
- The AMC status LED will blink green when the boot is ready.