Actions

Difference between revisions of "ABSD Billing"

From Zenitel Wiki

(Call charging overview)
 
(47 intermediate revisions by 5 users not shown)
Line 1: Line 1:
New Data protocol messages
+
ABSD = AlphaCom Billing Service Daemon
  
[[CDC_STATE]] from AMCD to ABSD <br\>
+
A AlphaCom can host a ABSD process for billing services. ABSD requires a license to be inserted, and the application it self runs from local flash filesystem. ABSD handle the realtime authorization and charging of outgoing calls. Configuration and invoicing is handled by a BillingWeb application.
[[CDC_CMD]] from ABSD to AMCD <br\>
 
  
 +
The ABSD software communicates with the local AMCD using Stentofon Simple Link Layer. The ABSD software is defined as device number 198, and connects to local AMCD on TCP port 127.0.0.1/40002. In AlphaNet, remote AlphaComs communicates with ABSD via the hosting AMCD using the normal AlphaNet routing.
  
== Basic Concept ==
+
[[Category:Billing]]
 
 
CDC = Call Detail Control
 
ABSD = AlphaCom Billing Service Daemon
 
 
 
A AlphaCom can host a ABSD process for billing services. ABSD requires an external CIFS mounted network disk for the data storage, but the application  it self runs from local flash filesystem. ABSD handle the realtime authorization and charging of outgoing calls. Configuration and invoicing is handled by a BillingWeb application.
 
 
 
The ABSD software communicates with the local AMCD using [[Stentofon Simple Link Layer]].
 
The ABSD software is defined as [[device]] number '''198''', and connects to local AMCD on TCP port 127.0.0.1/'''40002'''. In AlphaNet, remote AlphaComs communicates with ABSD via the hosting AMCD using the normal AlphaNet routing.
 
 
 
== Startup Sequence ==
 
 
 
At startup ABSD sends "#!ABSD 0/198 VER:xxxx" + a [[RESET_TAKEN]] message.
 
 
 
AMCD responds to RESET_TAKEN message with [[COMMAND_RESPONSE]]. Response code is 1 = License OK,  or 4 = not license.
 
 
 
== Call charging overview ==
 
 
 
AlphaCom behavior is based on adding CDC handling to directory numbers using feature 81, Call to remote EXCHANGE and 83, Direct Global Number. When dialling feature 81/83 to ''dest_node'', AMCD checks .module_profile.node_profile[''dest_node''].''absd_node''. If ''absd_node'' is different from null, CDC handling is activated for the call. ''dest_node'' is usually a SIP-server. ''absd_node'' is the node number hosting the ABSD. This programming will be done from AlphaPro, "net routing"/"Advanced settings". ''absd_node'' must be set in all AlphaComs which are to use the billing service.
 
 
 
When CDC handlig is active, AMCD buffers all dialled by the user, as well forwards the digits to ABSD as [[CDC_STATE]](,,DIGIT,). ABSD decides whether digits are PIN code, trunk number, or digits to be sent to SIP.
 
 
 
When ABSD has recognized a PIN code or a trunk number, it sends [[CDC_CMD]] back to AMCD. The CDC_CMD contains code for the current state of dialing, and the number of digits which was associated with this part of the dialing sequence. AMCD removes the given number of digits from the start of the buffer. When ABSD sends CDC_CMD(,,TRUNK_SET...), AMCD opens the SIP connection, and send the remaining buffered digits to the SIP connection.
 
 
 
== AlphaCom User interface for dialling ==
 
* When dial PIN
 
** Short pip  (handset off dialling)
 
** Display * ?
 
* When SIP connection starts:
 
** Reset display line 2 dont show PIN/trunk code
 
** Dialtone from SIP
 
 
 
== Digit Collection ==
 
'''Example 1:'''<br\>
 
System setup: <br\>
 
AudioCodes SIP gateway, trunk line 1 programmed with number 0047. <br\>
 
0047 programmed in AlphaCom as feature 83 global number with flag for Call Detail Control.<br\>
 
 
 
WCSD programmed with pin code "12" for user "101" <br\>
 
 
 
User "101" dials trunk extension "0047" then local number 64871300
 
 
 
AMCD                                                        WCSD
 
CDC_STATE (START,      REF, 101, 0047) ----->            (Starts new billing process)
 
CDC_STATE (PIN_DIGIT,  REF, 101,    1) ----->            (Verify pin digits)
 
CDC_STATE (PIN_DIGIT,  REF, 101,    2) ----->
 
                                        <-----              CDC_CMD (REF, OK)  (Pin OK)
 
    (Send INVITE to SIP GW, SIP-trunk dial tone)
 
...
 
CDC_STATE (ESTABLISHED, REF, 101, 0047) ----->            (SIP connection established)
 
CDC_STATE (TRUNK_DIGIT, REF, 101,    6) ----->            (Collect digits for billing information)
 
CDC_STATE (TRUNK_DIGIT, REF, 101,    4) ----->           
 
  digits....871300                                          (When user stops dialing start billing?)
 
....
 
CDC_STATE (ACTIVE,      REF, 101, 0047) ----->            (Received every 10 sec as a heartbeat)
 
.....
 
CDC_STATE (DISCONNECT,  REF, 101, 0047) ----->            (Conversation disconnected)
 
 
 
 
 
When the link to the SIP gateway is established AlphaCom has no knowledge if the user reach a destination or not.
 
 
 
'''Example 2:'''<br\>
 
System setup: <br\>
 
SIP call manager <br\>
 
0047 programmed in AlphaCom as feature 81 Area code with flag for Call Detail Control and digit collection.<br\>
 
 
 
WCSD programmed with pin code "12" for user "101" <br\>
 
 
 
User "101" dials trunk extension "0047"
 
 
 
AMCD                                                        WCSD
 
CDC_STATE (START,      REF, 101, 0047) ----->            (Starts new billing process)
 
CDC_STATE (PIN_DIGIT,  REF, 101,    1) ----->            (Verify pin digits)
 
CDC_STATE (PIN_DIGIT,  REF, 101,    2) ----->
 
(New dial tone from AMC)                <-----              CDC_CMD (REF, OK)  (Pin OK)
 
CDC_STATE (TRUNK_DIGIT, REF, 101,    6) ----->            (Collect digits for billing information)
 
CDC_STATE (TRUNK_DIGIT, REF, 101,    4) ----->           
 
  digits..871300...                                        (When user stops dialing start billing?)
 
....
 
(User stops dialing or press M. SIP INVITE is sent with all collected digits 64871300)
 
...
 
CDC_STATE (ESTABLISHED, REF, 101, 0047) ----->            (SIP connection established)
 
....
 
CDC_STATE (ACTIVE,      REF, 101, 0047) ----->            (Received every 10 sec as a heartbeat)
 
.....
 
CDC_STATE (DISCONNECT,  REF, 101, 0047) ----->            (Conversation disconnected)
 
 
 
 
 
Dependent on the call manager the ESTABLISHED message can arrive during ringing or when the B-side actually lifting the handset.
 
 
 
== Failure situations ==
 
 
 
'''Illegal pin code'''
 
 
 
AMCD                                                        WCSD
 
CDC_STATE (START,      REF, 101, 0047) ----->            (Starts new billing process)
 
CDC_STATE (PIN_DIGIT,  REF, 101,    1) ----->            (Verify pin digits)
 
CDC_STATE (PIN_DIGIT,  REF, 101,    3) ----->
 
                                        <-----              CDC_CMD (REF, NOT_OK)  (Pin not OK)
 
    (User get failure tone and disconnect)
 
CDC_STATE (DISCONNECT,  REF, 101,0047)  ----->            (Conversation disconnected)
 
...
 
 
 
'''No reply from billing WCSD'''
 
 
 
AMCD                                                        WCSD
 
CDC_STATE (START,      REF, 101, 0047) ----->            (Starts new billing process)
 
CDC_STATE (PIN_DIGIT,  REF, 101,    1) ----->            (Verify pin digits)
 
CDC_STATE (PIN_DIGIT,  REF, 101,    2) ----->
 
....                                     
 
timeout after 3 sec, continue call setup
 
  (Send INVITE to SIP GW, SIP-trunk dial tone)
 
...
 
CDC_STATE (ESTABLISHED, REF, 101, 0047) ----->            (SIP connection established)
 
CDC_STATE (TRUNK_DIGIT, REF, 101,    6) ----->            (Collect digits for billing information)
 
CDC_STATE (TRUNK_DIGIT, REF, 101,    4) ----->   
 
  .....
 
 
 
'''Illegal number series dialed'''
 
AMCD                                                        WCSD
 
CDC_STATE (START,      REF, 101, 0047) ----->            (Starts new billing process)
 
CDC_STATE (PIN_DIGIT,  REF, 101,    1) ----->            (Verify pin digits)
 
CDC_STATE (PIN_DIGIT,  REF, 101,    2) ----->
 
                                        <-----              CDC_CMD (REF, OK)  (Pin OK)
 
    (Send INVITE to SIP GW, SIP-trunk dial tone)
 
...
 
CDC_STATE (ESTABLISHED, REF, 101, 0047) ----->            (SIP connection established)
 
CDC_STATE (TRUNK_DIGIT, REF, 101,    8) ----->            (Collect digits for billing information)
 
CDC_STATE (TRUNK_DIGIT, REF, 101,    2) ----->           
 
CDC_STATE (TRUNK_DIGIT, REF, 101,    0) ----->           
 
                                        <-----              CDC_CMD (REF, DISCONNECT)  (Illegal number series 820xxx)
 
(User get failure tone and disconnect)
 
CDC_STATE (DISCONNECT,  REF, 101, 0047) ----->            (Conversation disconnected)
 
....
 

Latest revision as of 09:55, 2 September 2010

ABSD = AlphaCom Billing Service Daemon

A AlphaCom can host a ABSD process for billing services. ABSD requires a license to be inserted, and the application it self runs from local flash filesystem. ABSD handle the realtime authorization and charging of outgoing calls. Configuration and invoicing is handled by a BillingWeb application.

The ABSD software communicates with the local AMCD using Stentofon Simple Link Layer. The ABSD software is defined as device number 198, and connects to local AMCD on TCP port 127.0.0.1/40002. In AlphaNet, remote AlphaComs communicates with ABSD via the hosting AMCD using the normal AlphaNet routing.