Difference between revisions of "Automatic Gain Control (AGC)"
From Zenitel Wiki
| Line 35: | Line 35: | ||
*'''Enable AGC''': Check the box to enable automatic volume control. Volume is adjusted according to the ambient noise level. The AVC will perform better if the loudspeaker volume is set to a fairly low level, as this will give the AVC a more dynamic range for adjustments. Note that the AVC adjustment is disabled while the speaker is playing audio. Adjustments are made in silent periods (min. 100 ms silence required). | *'''Enable AGC''': Check the box to enable automatic volume control. Volume is adjusted according to the ambient noise level. The AVC will perform better if the loudspeaker volume is set to a fairly low level, as this will give the AVC a more dynamic range for adjustments. Note that the AVC adjustment is disabled while the speaker is playing audio. Adjustments are made in silent periods (min. 100 ms silence required). | ||
| − | + | ||
*'''AGC mode''': Check to open for more advanced AVC settings | *'''AGC mode''': Check to open for more advanced AVC settings | ||
* '''AGC gain profile''': Threshold level for the AVC to start working. Valid range: 30-80 dBA. Default is 55 dBA. | * '''AGC gain profile''': Threshold level for the AVC to start working. Valid range: 30-80 dBA. Default is 55 dBA. | ||
| − | + | * '''AGC speed''': Threshold level for the AVC to stop working. Valid range: 60-120 dBA. Default is 100 dBA. | |
Revision as of 16:38, 23 October 2023
|
This article is under construction! |
Zenitel IP devices supports Automatic Gain Control (AGC). The purpose of the AGC feature ..............
Default active???
Not config in TCIV+?
IC-Edge mode
Log in to the Edge Controller, and navigate to Edge Controller > System Configuration > Call and Audio, and enable "AGC":
SIP and ICX-AlphaCom mode
Log in to the Zenitel IP device.
- SIP mode: Navigate to SIP Configuration > Audio Settings, and enable "Automatic Gain Control (AGC)"
- ICX-AlphaCom mode: Navigate to Advanced ICX-AlphaCom > Audio Settings, and enable "Automatic Gain Control (AGC)"
Some additional settings are available in Advanced Configuration mode. Navigate to Audio Settings > Audio signal processing:
- Enable AGC: Check the box to enable automatic volume control. Volume is adjusted according to the ambient noise level. The AVC will perform better if the loudspeaker volume is set to a fairly low level, as this will give the AVC a more dynamic range for adjustments. Note that the AVC adjustment is disabled while the speaker is playing audio. Adjustments are made in silent periods (min. 100 ms silence required).
- AGC mode: Check to open for more advanced AVC settings
- AGC gain profile: Threshold level for the AVC to start working. Valid range: 30-80 dBA. Default is 55 dBA.
- AGC speed: Threshold level for the AVC to stop working. Valid range: 60-120 dBA. Default is 100 dBA.