Difference between revisions of "Configuration guide for School IP Intercom - AlphaCom mode"
From Zenitel Wiki
(→Special Function Keys) |
(→Special Function Keys) |
||
Line 14: | Line 14: | ||
[[File:School IC SpecialKeys.png|thumb|right|300px|Special Keys on the School Intercom]] | [[File:School IC SpecialKeys.png|thumb|right|300px|Special Keys on the School Intercom]] | ||
The School Intercom station has some special function keys: | The School Intercom station has some special function keys: | ||
− | *Emergency Button: | + | *Emergency Button: DAK Key 11 |
*Volume UP: DAK Key 1 | *Volume UP: DAK Key 1 | ||
*Volume DOWN: DAK Key 2 | *Volume DOWN: DAK Key 2 | ||
Line 23: | Line 23: | ||
=== Emergency Button === | === Emergency Button === | ||
− | The | + | The emergency button is connected to Input 1 on the station PCB, which is reported as DAK key 11. |
+ | (Note that on AMC xxx xxxx ) | ||
[[File:HotlineOff hook.PNG|thumb|left|500px|When input 3 is activated on station 144, the off-hook and on-hook status is reported to the AlphaCom]] | [[File:HotlineOff hook.PNG|thumb|left|500px|When input 3 is activated on station 144, the off-hook and on-hook status is reported to the AlphaCom]] |
Revision as of 15:16, 20 March 2017
This article is applicable for School IP Intercom used in AlphaCom mode.
Contents
Keyboard configuration
The correct keyboard configuration needs to be set. This is done via the web interface of the station:
- Navigate to Advanced AlphaCom > Keyboard
- Select Keyboard Type = 2
- Press “Save Keyboard Config”
Special Function Keys
The School Intercom station has some special function keys:
- Emergency Button: DAK Key 11
- Volume UP: DAK Key 1
- Volume DOWN: DAK Key 2
- Star key (*): DAK Key 3
- Hash key (#): DAK Key 4
These keys have no function by default, and needs to be configured.
Emergency Button
The emergency button is connected to Input 1 on the station PCB, which is reported as DAK key 11.
(Note that on AMC xxx xxxx )
The action string is: %chg($HOFF %1.ref,$HON %1.ref)
Volume UP
Enable the hotline function by selecting the hotline station in the listbox in Users & Stations, select the Station Type tab, and check the Hotline flagg:
In Users & Stations, select the DAK button, and enter the call destination on DAK 7:
If the hotline call should generate a Call Request instead, enter "I 623 I xxx" on DAK 7, where xxx is the target station. If the Call Request should be cleared when replacing the handset, enter "I626 I xxx" on DAK 8, else leave DAK 8 blank.
Volume DOWN
By default there is a 5.0 second delay from the handset is lifted until the call is placed. Often you want the call to be placed immediately. To change the delay time, select Exchange & System, System, Calls and Options.
Star (*) and Hash (#) keys
The Full Keypad models have three Direct Access Keys, D1 to D3, which will trigger DAK key 1 to DAK key 3 in the AlphaCom.
However, the hook switch connected to input 3 will also trigger DAK Key 3. Due to this conflict, button D3 cannot normally not be used.