Difference between revisions of "DAK key programming not working after SendAll"
From Zenitel Wiki
(Created page with "DAK key programming "disappears" Send/Get Modules Converted databases") |
Lennert.werf (talk | contribs) |
||
| (8 intermediate revisions by 4 users not shown) | |||
| Line 1: | Line 1: | ||
| − | DAK key programming | + | {{AI}} |
| + | It can happen that DAK key programming disappears or that changes in DAK key programming don't take effect after SendChg/All. Specially databases that are upgraded from v.8.x/9.x to 10/11.x can be affected by this fault. | ||
| − | Send/Get Modules | + | [[Image:Select_nodetype.png|thumb|Temporarily select Node Type 'AlphaCom']] |
| − | + | [[Image:Send_Get_Modules.png|thumb|All Modules should be selected]] | |
| + | |||
| + | It can happen that the 'Send/Get Modules' flags are not set correctly, and this will cause the DAK key problems. | ||
| + | |||
| + | The procedure for getting the correct settings: | ||
| + | * Open '''AlphaPro''' -> '''Exchange''' '''& System''' -> '''System''' | ||
| + | * Temporarily set the Node Type to 'AlphaCom'. The Send/Get Modules will now be visible. | ||
| + | * Make sure that all Modules are checked the Send/Get Modules box. | ||
| + | * Set the Node Type back to 'AlphaCom E' | ||
| + | * Click OK to save changes | ||
| + | |||
| + | |||
| + | [[Category:AlphaPro Troubleshooting]] | ||
Latest revision as of 10:54, 24 October 2023
It can happen that DAK key programming disappears or that changes in DAK key programming don't take effect after SendChg/All. Specially databases that are upgraded from v.8.x/9.x to 10/11.x can be affected by this fault.
It can happen that the 'Send/Get Modules' flags are not set correctly, and this will cause the DAK key problems.
The procedure for getting the correct settings:
- Open AlphaPro -> Exchange & System -> System
- Temporarily set the Node Type to 'AlphaCom'. The Send/Get Modules will now be visible.
- Make sure that all Modules are checked the Send/Get Modules box.
- Set the Node Type back to 'AlphaCom E'
- Click OK to save changes