Difference between revisions of "Device"
From Zenitel Wiki
| Line 8: | Line 8: | ||
! style="background:#ffdead;" width="600" |Device Function | ! style="background:#ffdead;" width="600" |Device Function | ||
|- | |- | ||
| − | | | + | | 0 || 0x00 || Invalid device (reserved NULL value) |
|- | |- | ||
| [[PIN_COUNTS]] || Response to the GET_PIN_COUNTS message | | [[PIN_COUNTS]] || Response to the GET_PIN_COUNTS message | ||
Revision as of 23:11, 19 June 2007
All data messages are addressed to a device. A device is always related to (owned by) a node. A full device address consists of <node> <device>.
<Device> is one byte.
Note that devices can both be physical boxes (e.g. RIO) or a function (Router).
| Value (decimal) | Value (Hex) | Device Function |
|---|---|---|
| 0 | 0x00 | Invalid device (reserved NULL value) |
| PIN_COUNTS | Response to the GET_PIN_COUNTS message | |
| SET_RCO | Turn the given remote control output on | |
| SET_RCO_OK | Positive response to the SET_RCO message | |
| SET_RCO_FAILED | Negative response to the SET_RCO message | |
| CLEAR_RCO | Turn the given remote control output off | |
| CLEAR_RCO_OK | Positive response to the CLEAR_RCO message | |
| CLEAR_RCO_FAILED | Negative response to the CLEAR_RCO message | |
| PULSE_RCO | Generate a pulse with the defined length | |
| PULSE_RCO_OK | Positive response to the PULSE_RCO message | |
| PULSE_RCO_FAILED | Negative response to the PULSE_RCO message | |
| POLL_RCI | Poll the given remote control input once | |
| SCAN_RCI_ONCE | Scan input until defined condition is met, then report to exchange | |
| SCAN_RCI_ACK | Positive response to the SCAN_RCI_ONCE message | |
| RCI_IS_ON | Response to the POLL_RCI and SCAN_RCI_ONCE messages, input pin is on | |
| RCI_IS_OFF | Response to the POLL_RCI and SCAN_RCI_ONCE messages, input pin is off | |
| SCAN_END_ACK | Acknowledgment to the RCI_IS_OFF and RCI_IS_ON messages |