Difference between revisions of "ENA Amplifier - Calibrating the loudspeaker lines"
From Zenitel Wiki
(→Calibration from the amplifier GUI) |
|||
| Line 9: | Line 9: | ||
== Calibration from the amplifier GUI == | == Calibration from the amplifier GUI == | ||
| − | + | Use the [[ENA User Interface|Menu Selection Knob]] on the front of the amplifier, and navigate to '''Settings''' > '''Audio Output Monitoring'''. | |
== Calibration from the amplifier web interface == | == Calibration from the amplifier web interface == | ||
Revision as of 16:12, 10 April 2018
{A}} The ENA amplifier can monitor impedance changes on each channel. This is used to detect fault such as load change, open/short and ground faults. A loud change must be minimum 15% before it is reported as an error. The Speaker Line Monitoring (SLM) can be individually turned on or off for each channel in Monitoring and Lines > Line Control > Channel 1/2 > Line Monitoring.
In order to make the Line Monitoring work, the speaker line needs to be calibrated. This can be done in two ways:
- From the Amplifier GUI or
- From the web interface of the amplifier
The option Suspend Monitoring will turn off monitoring when there is audio on the channel output.
Calibration from the amplifier GUI
Use the Menu Selection Knob on the front of the amplifier, and navigate to Settings > Audio Output Monitoring.