Difference between revisions of "ENA Amplifier - Calibrating the loudspeaker lines"
From Zenitel Wiki
| Line 6: | Line 6: | ||
* '''Short:''' A large load change indicating a large additional load will be considered a short. | * '''Short:''' A large load change indicating a large additional load will be considered a short. | ||
* '''Ground fault:''' Any ground fault will be detected. Can be individually turned on or off. | * '''Ground fault:''' Any ground fault will be detected. Can be individually turned on or off. | ||
| − | |||
| − | |||
In order to make the Line Monitoring work, the speaker line '''must be calibrated'''. This can be done in two ways: | In order to make the Line Monitoring work, the speaker line '''must be calibrated'''. This can be done in two ways: | ||
| Line 36: | Line 34: | ||
== Calibration from the amplifier web interface == | == Calibration from the amplifier web interface == | ||
| − | + | The Speaker Line Monitoring (SLM) can be individually must be turned on in [[ENA_Configuration_-_AlphaCom_mode#Line_Control|Monitoring and Lines > Line Control > Channel 1/2 > Line Monitoring]]. | |
Revision as of 16:34, 10 April 2018
The ENA amplifier can monitor impedance changes on each channel. This is used to detect fault such as load change, open/short and ground faults.
- Load Change: Exigo considers a change of more than 15% a load change. This is done to prevent false fault reports due to variations in temperature, speaker loop configurations etc. Can be individually turned on or off.
- Open: If more than 90% of the load is removed Exigo will detect the line as open.
- Short: A large load change indicating a large additional load will be considered a short.
- Ground fault: Any ground fault will be detected. Can be individually turned on or off.
In order to make the Line Monitoring work, the speaker line must be calibrated. This can be done in two ways:
- From the Amplifier GUI or
- From the web interface of the amplifier
The option Suspend Monitoring will turn off monitoring when there is audio on the channel output.
Calibration from the amplifier GUI
Use the Menu Selection Knob on the front of the amplifier, and navigate to Settings > Audio Output Monitoring.
Selecting Audio Output Monitoring will give you this sub menu:
Select Monitor will give you this sub menu:
Here you select Calibrate. The speaker loop is now monitored.
Repeat the procedure for the second channel if in use
Calibration from the amplifier web interface
The Speaker Line Monitoring (SLM) can be individually must be turned on in Monitoring and Lines > Line Control > Channel 1/2 > Line Monitoring.