Difference between revisions of "Group Call - PTT function"
From Zenitel Wiki
(→DAK event) |
|||
Line 1: | Line 1: | ||
− | {{ | + | {{AI}} |
This article describes how to configure a DAK key on a station to activate a Group Call when the key is pressed, and cancel the group call when the DAK key is released. | This article describes how to configure a DAK key on a station to activate a Group Call when the key is pressed, and cancel the group call when the DAK key is released. | ||
Line 29: | Line 29: | ||
− | [[Category:Applications]] | + | |
+ | [[Category:AlphaCom Applications]] | ||
+ | [[Category: ICX-AlphaCom Applications]] |
Revision as of 13:10, 23 May 2022
This article describes how to configure a DAK key on a station to activate a Group Call when the key is pressed, and cancel the group call when the DAK key is released.
Configure the group to use "Automatic M-key"
In AlphaPro, select the Group Call, and enable "Automatic M-key". When enabled, there is no need to press the M-key to open the microphone during the group call:
DAK event
In the Event Handler, the event 30 (Station Input or Station DAK key) is triggered when a DAK Key is pressed.
The following event will activate group call 85 when the DAK key number 3 (= Subevent 3) is pressed, and cancel when the key is released.
In AlphaPro, press Users & Stations button, select a station from the listbox, and press Events. Insert a new event with the following properties:
Action commands:
IF %chg(1,0) $DD L%1.dir L85 stop ENDIF $C L%1.dir
Note that in the DAK table of station 164 the DAK key 3 must be blank.