Difference between revisions of "HTTP string: Send from AlphaCom"
From Zenitel Wiki
(→Example: Control PTZ on an Axis camera) |
|||
| Line 26: | Line 26: | ||
== Example: Control PTZ on an Axis camera == | == Example: Control PTZ on an Axis camera == | ||
| + | When pushing DAK 1 on an intercom station you want to pan an Axis camera 10 degrees to the left. Pushing DAK 2 should pan the camera 10 degrees to the right. | ||
| − | |||
| − | Relative pan : 10 degrees right | + | The http commands are: |
| + | *Relative pan : 10 degrees right | ||
http://myserver/axis-cgi/com/ptz.cgi?rpan=10 | http://myserver/axis-cgi/com/ptz.cgi?rpan=10 | ||
| − | Relative pan : 10 degrees left | + | *Relative pan : 10 degrees left |
http://myserver/axis-cgi/com/ptz.cgi?rpan=-10 | http://myserver/axis-cgi/com/ptz.cgi?rpan=-10 | ||
Revision as of 10:54, 13 September 2017
Contents
HTTP GET via EDO Port
You can send HTTP GET to third-party systems using EDO ports and Event Handler.
Set up EDO port
In AlphaPro select Exchange & System > Serial Ports > Configure EDIO port
Port-Type: TCP/IP Client
IP-Address: destination IP
Port: destination port, usually 80 when HTTP.
Keep-Alive: off
Create Event
Use EDO command to send HTTP GET on the configured port.
Example using DAK 1 to send HTTP GET:
EDO 1 "GET /triggerevent?variable1=test1&variable2=test2 HTTP/1.1\r\nHost: 10.5.101.110\r\nConnection: Keep-Alive\r\n" EDO 1 "Accept: */*\r\n\r\n"
A string generated by the EDO command can contain maximum 128 characters. If the http string exceeds this length, one can simply use multiple EDO commands.
Example: Control PTZ on an Axis camera
When pushing DAK 1 on an intercom station you want to pan an Axis camera 10 degrees to the left. Pushing DAK 2 should pan the camera 10 degrees to the right.
The http commands are:
- Relative pan : 10 degrees right
http://myserver/axis-cgi/com/ptz.cgi?rpan=10
- Relative pan : 10 degrees left
http://myserver/axis-cgi/com/ptz.cgi?rpan=-10