Actions

Hotline Call

From Zenitel Wiki

Revision as of 09:58, 24 May 2022 by Asle (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
AI.png

When lifting the handset of a station, a call can automaticaly be placed to a preconfigured number. This is known as Hotline Call. By default there is a delay of 5 seconds before the call is made, allowing the user to dial a different number on the keypad. This delay can be set to a low value if immediate call is required.

HotlineCall3.PNG
Hotline Call


Configuration

Enable the hotline function by selecting the hotline station in the listbox in Users & Stations, select the Station Type tab, and check the Hotline flag:

Enable the Hotline Call flag



In Users & Stations, select the DAK button, and enter the call destination on DAK 7:

Call to station 321 when lifting the handset


Option: If the hotline call should generate a Call Request instead, enter "I 623 I xxx" on DAK 7, where xxx is the target station. If the Call Request should be cleared when replacing the handset, enter "I626 I xxx" on DAK 8, else leave DAK 8 blank.

Send Call Request to station 101 when lifting the handset, delete the Call request when replacing the handset



Hotline Call Delay

By default there is a 5.0 second delay from the handset is lifted until the call is placed. Often you want the call to be placed immediately. To change the delay time, select Exchange & System, System, Calls and Options. Hotline Call Delay.

Default hotline delay is 5.0 sec. Change from 50 to 0 for immediate call