Actions

Difference between revisions of "INCA Display Station Restore Factory Defaults"

From Zenitel Wiki

Line 3: Line 3:
 
The procedure may also be applied to the [[IP Master Station Kit - 1008093000]] if a Display is connected.
 
The procedure may also be applied to the [[IP Master Station Kit - 1008093000]] if a Display is connected.
  
The [[IP DualDisplay]] station can also be restored through an [[alternative procedure]].
+
The [[IP Dual Display Station - 1008007000|IP DualDisplay]] station can also be restored through an [[INCA_Station_Restore_Factory_Defaults|alternative procedure]].
  
 
The Station Menu is only available when the IP Station is in offline mode.
 
The Station Menu is only available when the IP Station is in offline mode.

Revision as of 05:53, 25 October 2016

This procedure is the recommended procedure for all IP Stations with Display.

The procedure may also be applied to the IP Master Station Kit - 1008093000 if a Display is connected.

The IP DualDisplay station can also be restored through an alternative procedure.

The Station Menu is only available when the IP Station is in offline mode.

  • Make sure the IP Station is disconnected from the AlphaCom XE exchange.
  • Press the Setup button beneath the display
  • Enter the password 1851 and press the Ok button.
  • Navigate to Load defaults and press the Sel button.
  • Press the Sel button to load factory defaults.
Load Defaults in IP Display Station - 1.PNG
Load Defaults in IP Display Station - 2.PNG

The station will now restart with factory settings.