Difference between revisions of "INCA Display Station Restore Factory Defaults"
From Zenitel Wiki
| Line 1: | Line 1: | ||
This procedure is the recommended procedure for all IP Stations with Display. | This procedure is the recommended procedure for all IP Stations with Display. | ||
| − | |||
| − | |||
| − | |||
| − | |||
The Station Menu is only available when the IP Station is in offline mode. | The Station Menu is only available when the IP Station is in offline mode. | ||
| Line 17: | Line 13: | ||
The station will now restart with factory settings. | The station will now restart with factory settings. | ||
| + | |||
| + | The procedure may also be applied to the [[IP Master Station Kit - 1008093000]] if a Display is connected. | ||
| + | |||
| + | The [[IP Dual Display Station - 1008007000|IP DualDisplay]] station can also be restored through an [[INCA_Station_Restore_Factory_Defaults|alternative procedure]]. | ||
[[Category: INCA - Restore Factory Defaults and Software Upgrade]] | [[Category: INCA - Restore Factory Defaults and Software Upgrade]] | ||
Revision as of 06:54, 25 October 2016
This procedure is the recommended procedure for all IP Stations with Display.
The Station Menu is only available when the IP Station is in offline mode.
- Make sure the IP Station is disconnected from the AlphaCom XE exchange.
- Press the Setup button beneath the display
- Enter the password 1851 and press the Ok button.
- Navigate to Load defaults and press the Sel button.
- Press the Sel button to load factory defaults.
The station will now restart with factory settings.
The procedure may also be applied to the IP Master Station Kit - 1008093000 if a Display is connected.
The IP DualDisplay station can also be restored through an alternative procedure.