Difference between revisions of "INCA Hotline station Restore Factory Defaults"
From Zenitel Wiki
m (1 revision imported) |
|||
| (One intermediate revision by one other user not shown) | |||
| Line 17: | Line 17: | ||
*Password: '''alphaadmin''' | *Password: '''alphaadmin''' | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
[[Category: INCA - Restore Factory Defaults and Software Upgrade]] | [[Category: INCA - Restore Factory Defaults and Software Upgrade]] | ||
Latest revision as of 15:10, 5 February 2018
This procedure is applicable for the IP Hotline Station.
Procedure:
This procedure will load factory defalt settings in the station. The unit can be set to use either Static IP or DHCP.
- Lift the handset, and power up the station.
- Replace the handset after exactly 2 flashes of the station LED.
- Let the LED flash for exactly 2 more times (Static IP) or exactly 4 more times (DHCP), then lift the handset again.
- Keep the handset lifted until the LED flashes fast 2 times (Static IP) or flashes fast 4 times (DHCP) indicating a successful reset.
- Replace the handset and the station will restart with the factory default settings.
Factory default values:
- Station Mode: Pulse
- Station IP address: 169.254.1.100 (Static) or DHCP
- Username: admin
- Password: alphaadmin