IP DECT Alarm Server - Quick Setup Guide

This article describes the minimum setup requirements to set up the IP DECT Alarm Server for use with the IP DECT Server 6000.

Connecting the IP DECT Alarm Server

1 Connect the power supply to the Alarm Server
2 Connect the LAN2 port to a PC using a crossed ethernet cable or a switch/hub and patch cables via LAN.
3 Turn on the power to the Alarm Server

The SYS LED indicator on the Alarm Server will light up a steady green.

Configuring the IP Interface and Web Server

Accessing the embedded web server

1 Set up the PC to use an IP address on the 192.168.1.0 net range. For example 192.168.1.2.
2 Enter the default Alarm Server IP address (192.168.1.1) in you browser address field.
3 Enter default user name and password in the login window.
  Default Username: admin
  Default Password: cms
4 Click Login
5 In the System menu, click the LAN tab, and enter an IP address suitable to your network in the LAN2 settings.
6 Click Reset Required that appears on the bottom of the page. A new page opens, click Reset
7 Login to the Alarm Server again, using the new IP address.

1. Set up the PC to use an IP address on the 192.168.1.0 net range. For example 192.168.1.2.
2. Enter the default Alarm Server IP address (192.168.1.1) in you browser address field.
3. Enter default user name and password in the login window.
   1. Default Username: admin
   2. Default Password: cms
4. Click Login
5. In the System menu, click the LAN tab, and enter an IP address suitable to your network in the LAN2 settings.
6. Click Reset Required that appears on the bottom of the page. A new page opens, click Reset
7. Login to the Alarm Server again, using the new IP address.