Actions

Difference between revisions of "IP Flush Master Gooseneck"

From Zenitel Wiki

Line 12: Line 12:
 
For board connectors, see [[INCA Master Station Kit Board Connectors]].
 
For board connectors, see [[INCA Master Station Kit Board Connectors]].
  
[[File:IP_Master_Gooseneck_Microphone_Installation.PNG]]<br/>
+
[[File:IP_Master_Gooseneck_Microphone_Installation.PNG|350px]]<br/>
 
Installing the Gooseneck Microphone
 
Installing the Gooseneck Microphone
 
<br style="clear:both;" />
 
<br style="clear:both;" />

Revision as of 17:04, 16 March 2017

Gooseneck Microphone. item no 1008097500

This microphone is for the IP Flush Master Station and the IP Master Station Kit.

To install the Gooseneck Microphone:

  • Remove the cover plug from the opening for the microphone on the front panel.
  • Thread the microphone cable through the opening, the lock washer and nut.
  • Tighten the nut on the microphone’s threaded stud.
  • Insert the microphone’s IDC socket into the upper two pins of the 3-pin header (J7) located at the lower left side of the station. The signal wire (white) should be on the top pin while the ground wire (green) should be on the bottom pin.
  • Slide the S1 switch (bottom back of station) to EXT to activate the external microphone function.

For board connectors, see INCA Master Station Kit Board Connectors.

IP Master Gooseneck Microphone Installation.PNG
Installing the Gooseneck Microphone


Gooseneck microphone connection
Gooseneck microphone connection, detailed


Related articles