Actions

ITSV-1 Restore Factory Defaults

From Zenitel Wiki

Revision as of 09:22, 24 July 2020 by Nikica (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
AEPS.png

This article describes how to restore factory defaults of the ITSV-1 station.

Restore to Factory Default

Restore to Factory Default via LCD Menu

  1. On ITSV-1 idle screen, press MENU button and tap on System settings. Or go to onscreen MENU > Settings
  2. Select Advanced Settings > Factory Reset, the following figure will show
  3. Factory Reset


  4. Press OK, a confirmation message will show. Select "Clear the SD Card" if you would like to delete all pictures, videos and other files from the SD card storage on the ITSV-1
  5. Confirm the reset


  6. Press OK to confirm

Restore to Factory Default via the Web GUI

  1. Login to ITSV-1 Web GUI and go to Maintenance>Upgrade page
  2. At the bottom of the page, click on the Reset button for Factory reset. Select "Clear the SD Card" if you would like to delete all the picture, videos and other files from the SD card storage on the ITSV-1
  3. Factory Reset


  4. A dialog box will pop up to confirm factory reset. The dialog box is created at the top of the screen
  5. Confirm the reset


  6. Click OK to restore the ITSV-1 to factory settings

Restore to Factory Default via Hard Keys

If users could not access web GUI for factory reset, or when the ITSV-1 cannot boot up, follow the steps below to reset the ITSV-1 via hard keys.

  1. Turn off the ITSV-1
  2. Press and hold both 1 and 9 keys at the same time until it enters the factory reset mode
  3. The ITSV-1 will boot up with factory default settings

Factory default values

  • Station IP address: DHCP
  • Username: admin
  • Password: alphaadmin