Difference between revisions of "ITSV-2 & ITSV-3 Restore Factory Defaults"
From Zenitel Wiki
(→Factory default values) |
(→Restore to Factory Default) |
||
| Line 7: | Line 7: | ||
* Select the '''Settings''' icon on the screen, and scroll down to the '''Advanced''' section. Select '''System Security''' > '''Factory Default''' | * Select the '''Settings''' icon on the screen, and scroll down to the '''Advanced''' section. Select '''System Security''' > '''Factory Default''' | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
===Restore to Factory Default via the Web GUI=== | ===Restore to Factory Default via the Web GUI=== | ||
Revision as of 08:57, 20 October 2020
This article describes how to restore factory defaults of the ITSV-3 station.
Restore to Factory Default
Restore to Factory Default via LCD Menu
- Select the Settings icon on the screen, and scroll down to the Advanced section. Select System Security > Factory Default
Restore to Factory Default via the Web GUI
- Login to ITSV-1 Web GUI and go to Maintenance>Upgrade page
- At the bottom of the page, click on the Reset button for Factory reset. Select "Clear the SD Card" if you would like to delete all the picture, videos and other files from the SD card storage on the ITSV-1
- A dialog box will pop up to confirm factory reset. The dialog box is created at the top of the screen
- Click OK to restore the ITSV-1 to factory settings
Restore to Factory Default via Hard Keys
If users could not access web GUI for factory reset, or when the ITSV-1 cannot boot up, follow the steps below to reset the ITSV-1 via hard keys.
- Turn off the ITSV-1
- Press and hold both 1 and 9 keys at the same time until it enters the factory reset mode
- The ITSV-1 will boot up with factory default settings
Factory default values
- Station IP address: DHCP
- Username: admin
- Password: alphaadmin
The very first time you log in you are prompted to change the password.
|
Make sure to make a note of the new password! |