Actions

Difference between revisions of "LenelS2 OnGuard - ICX-AlphaCom Integration"

From Zenitel Wiki

(Article Scope)
Line 29: Line 29:
  
 
Note that when upgrading to a newer version of OnGuard, the Accessory Add-On installation needs to be performed again. All database information will still be present.
 
Note that when upgrading to a newer version of OnGuard, the Accessory Add-On installation needs to be performed again. All database information will still be present.
 +
 +
===ICX System Configuration===
 +
Use AlphaPro, the standard ICX programming tool to enter the parameters to enable communication between ICX and OnGuard.
 +
* Go to Exchange & System > Serial Ports and set the following parameters:
 +
** MPC Data Protocol
 +
** TCP/IP server
 +
** Enter a Port number
 +
*** In the screenshot, port 3001 is used as an example, and is also the default port configured in OnGuard
 +
 +
[[File:lenel_alphaproport.png|thumb|left|700px|The port must be defined and opened in the ICX firewall]]

Revision as of 15:09, 20 December 2019

AI.png

Introduction

Article Scope

This article describes the interface of Vingtor-Stentofon ICX and AlphaCom XE platforms with OnGuard. OnGuard users will be able to configure ICX and AlphaCom XE as a communication platform from within OnGuard System Administration.

ICX and AlphaCom XE offer advanced communication and control capabilities. They provide the voice of security. This article includes descriptions of setup and configuration, operation, and any limitations and/or notes surrounding the solution. Setup and operation of ICX and AlphaCom XE are very similar, as ICX is built on the AlphaCom XE application software. Where this does not cause any confusion, only reference will be made to the ICX.

This article assumes that the reader is familiar with the setup of OnGuard and ICX.

Prerequisites

Pre-Installation Checklist

  • Use AlphaPro, the standard ICX programming tool to enter the parameters to enable communication between ICX and OnGuard.
  • ICX software has been upgraded to version 1.0.3.1 or higher
  • AlphaCom software has been upgraded to version 13.1.3.3 or higher
  • OnGuard software is an actively supported version
  • Zenitel intercom stations have been configured and point to the ICX
  • Programming of the exchange (if necessary)
  • OnGuard server configured on a compatible Operating System

Licensing

  • Maximum Number of Intercom Exchanges (SWG-1340) – Contact VAR or Lenel
  • ICX: 1002602400 - ILI-IF


Installation and Configuration

Install Accessory Add-On

  • Install x.x Zenitel ICX Accessory Add-On.msi, where x.x refers to the OnGuard software version

Note that when upgrading to a newer version of OnGuard, the Accessory Add-On installation needs to be performed again. All database information will still be present.

ICX System Configuration

Use AlphaPro, the standard ICX programming tool to enter the parameters to enable communication between ICX and OnGuard.

  • Go to Exchange & System > Serial Ports and set the following parameters:
    • MPC Data Protocol
    • TCP/IP server
    • Enter a Port number
      • In the screenshot, port 3001 is used as an example, and is also the default port configured in OnGuard
The port must be defined and opened in the ICX firewall