Actions

Light Industrial Master Station with Loudspeaker - 1007080000

From Zenitel Wiki

Revision as of 14:54, 15 August 2018 by Asle (talk | contribs) (Private/Open setting)
AlphaCom icon 300px.png
Light Industrial Master Station

The Light Industrial Master Station is an analog intercom station. It is connected to an ASLT line card in an AlphaCom XE7, AlphaCom XE20 or AlphaCom XE26 server using 2 pairs of wires.

Highlights

  • Fully equipped splashproof master station with free access to all extensions and features
  • Flame- and chip-resistant plastic casing. Key board foil of UV-cured PVC. Resistant to corrosive fluids
  • Electret microphone and red microphone live lamp
  • Screw terminals for easy connection of installation cables
  • Built-in loudspeaker and possibility to connect an external speaker. Sound level adjustable with a potentiometer inside the station
  • Built-in 10W (8 Ohm) VOX operated power amplifier for external loudspeaker


Connections

Connection details:

708x Connections.png


For details on connection at the AlphaCom server side, see ASLT - AlphaCom Subscriber Line Board

Private/Open setting

The jumper S1 determines if the station is in private or open mode.

  • S1 in upper position: Open mode
  • S1 inn lower position: Private mode


External loudspeaker

External loudspeaker powered from the exchange:

  • Connect an external 20 ohm loudspeaker to the L.SP. output
  • Set the jumpers S5 and S9 in the lower position
  • Adjust volume with RP2

Using the built-in 10 watt amplifier:

  • Connect an external 8 ohm loudspeaker to the L.SP. output
  • Set the jumpers S5 and S9 in the upper position
  • Connect a 12VAC transformer as indicated in the above drawing
  • Adjust volume with RP5


Handset connection

When handset is connected, open shunt S8 and S11.

7080 handset conn.PNG


Handset troubleshooting

  • Symptom: When an industrial station type 100 7080 000 is equipped with a handset there is a knows issue related to the handset operation: when the handset is replaced (on-hook) during conversation, the conversation does not cancel.
  • Solution: A component must be changed on the station PCB; A100C01433, in order to make the converstion cancel. Change capacitor C14 (47µF/100V) to 4,7µF/63V.
7080 handset cancel.PNG



Dimensional Drawing

1007080000-dimensions 0.jpg

Related articles